(*see terms)
Customising a blind to meet your bespoke requirements is quick and easy. Simply enter the dimensions of your blind, and then specify your requirements in step 2.
Slat Width
The slat width refers to the width of each individual slat or blade of the blind, choose from the available size options.
Width
The width is the measurement taken horizontally from left to right across the area where your blind is to be located.
Drop
The drop is the measurement taken vertically from the top of the blind to the bottom of the blind.
Please specify your requirements from the options below
Exact/Recess
Exact is selected when you require you're blind to be hung on the wall outside of your window recess area, where your blinds will then be made to your exact measurements.Recess is the internal area where your window is located, select recess when your blind is to be located within this area. There is no need to make any adjustments to your measurements as your blind will be made to fit the recess area perfectly.Please refer to the how to measure section to ensure you have measured correctly.
Raise/Lower
The raise and lower control enables the blind to be pulled up and down, select which side of the blind the raise and lower control should be located.
Tilt Control
The tilt control enables you to adjust the angle of the slats varying the amount of light to pass through the blind. Select which side of the blind you wish the tilt control to be located, ensure you choose the most practical side for ease of operation.
Sunflex Belgravia 29mm 3 Sided Bay ...
Was from £80.00
Now from £70.00
Save £10.00
